LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1564 (Body - Interior & Exterior - 2500 Hd) >> Exterior >> Box, Pickup >> Removal >> Ram Box Lid

Ram Box Lid

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0169746Courtesy of CHRYSLER GROUP, LLC
  1. Remove the two screws (3) from the latch cover (1).
  2. Remove the three bolts (2) from the latch cover (1).
  3. Route the escape handle (4) through the slot in the latch cover.
    GC0169742Courtesy of CHRYSLER GROUP, LLC
  4. If equipped with a lock actuator (2)-
    1. Disconnect and isolate the battery negative cable.
    2. Position the latch cover slightly away the latch.
    3. Disconnect the actuator wiring connector (3) and linkage (1).
      GC0169707Courtesy of CHRYSLER GROUP, LLC
    4. Remove the two wiring grommets (1) from the lid.
    5. Carefully, pull the wiring (2) out of the lid.
    GC0169743Courtesy of CHRYSLER GROUP, LLC
  5. Remove the two hinge bolts (2) from the hinge (1) and repeat on the opposite side.
  6. Remove the lid from the vehicle.
scientia non olet · About LEMON Manuals