Installation- Gasoline Engine
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Install the reservoir bracket to the pump housing (if equipped). Do not reuse the o-rings (install new o-rings).
Tighten bolts to specifications. Refer to PUMP, TECHNICAL SPECIFICATIONS .NOTE:
Ensure the reservoir (1) is fully seated onto the pump (3).
- Install the reservoir (1) to the bracket/pump body (3).
- Install the reservoir mounting bolts (2). Tighten bolts to specifications. Refer to PUMP, TECHNICAL SPECIFICATIONS .
- Install the power steering pump (3). Refer to PUMP, INSTALLATION .
- Install the serpentine drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
- Fill the power steering pump. Refer to PUMP, STANDARD PROCEDURE .