LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1562 (Steering System - 2500 Hd) >> Pump >> Installation >> Installation - Diesel Engine

Installation - Diesel Engine

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the power steering pump in the vehicle.
    NOTE:

    If necessary, transfer the power steering pump pulley.

  2. Align the power steering pump with the mounting holes on the rear bracket. Install the three power steering pump mounting bolts. Tighten the bolts to the proper torque specifications. Refer to PUMP, TECHNICAL SPECIFICATIONS .
    GC0161585Courtesy of CHRYSLER GROUP, LLC
  3. Tighten the rear power steering bracket to engine block bolt. Refer to PUMP, TECHNICAL SPECIFICATIONS .
  4. Connect the pressure line (2) to the pump with new washers. Tighten the pressure line to the proper specifications. Refer to PUMP, TECHNICAL SPECIFICATIONS .
  5. Connect the return hose (1) to the pump. Tighten the return hose to the proper specifications. Refer to PUMP, TECHNICAL SPECIFICATIONS .
  6. Install the serpentine belt. Refer to BELT, SERPENTINE, INSTALLATION .
  7. Install the left inner wheel well liner.
  8. Fill and bleed the power steering system. Refer to PUMP, STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals