LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1562 (Steering System - 2500 Hd) >> Linkage, Link And Coil >> End, Tie Rod, Link And Coil >> Removal >> RH - With Drag Link To Knuckle

RH - With Drag Link To Knuckle

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0161598Courtesy of CHRYSLER GROUP, LLC
  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Remove the tire and wheel.
  3. Loosen the nut/bolt (11) on the tie rod adjuster sleeve (8) as necessary.
    GC0152017Courtesy of CHRYSLER GROUP, LLC
  4. Remove the cotter key (1) and the drag link/tie rod to knuckle nut (2).
  5. Remove the tie rod (4) from the knuckle (5) with (special tool #C-3894-A, Puller, Tie Rod)and (special tool #10403, Separator, Drag Link)
  6. Remove the tie rod end (4) from the adjuster sleeve.
scientia non olet · About LEMON Manuals