LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1562 (Steering System - 2500 Hd) >> Linkage, Link And Coil >> End, Tie Rod, Link And Coil >> Removal >> LH - All

LH - All

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0161598Courtesy of CHRYSLER GROUP, LLC
  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Remove the tire and wheel.
  3. Remove tie rod to knuckle nut (1).
  4. Loosen the nut/bolt on the tie rod adjuster sleeve (11) as necessary.
    GC0108922Courtesy of CHRYSLER GROUP, LLC
  5. Remove tie rod (3) from the knuckle (2) with (special tool #8677, Remover, Ball Joint) (1).
  6. Remove the tie rod end from the adjuster sleeve.
scientia non olet · About LEMON Manuals