RH - Drag Link To Tie Rod
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Verify that equal number of thread engagement exists on both ends of adjuster sleeve and that the adjuster sleeve clamps cover the threaded ends.
NOTE:
Prior to installing tapered end suspension components, clean male and female surfaces with brake clean.
- Install the tie rod (12) into the adjuster sleeve (8) and into the steering knuckle.
- Install the drag link (3) to the tie rod (12). Install the nut (2) and tighten to specifications. Refer to LINKAGE, LINK AND COIL, TECHNICAL SPECIFICATIONS .
- Install the tire and wheels as necessary. Refer to WHEELS, STANDARD PROCEDURE .
- Remove the supports and lower the vehicle. Center the steering wheel and adjust the toe. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE
.NOTE:
Position the clamp on the sleeve so retaining bolt is located on the bottom side of the sleeve.
- After adjustment tighten tie rod adjustment sleeve clamp bolt (11) to specifications. Refer to LINKAGE, LINK AND COIL, TECHNICAL SPECIFICATIONS .