To Knuckle

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Verify that equal number of thread engagement exists on both ends of adjuster sleeve and that the adjuster sleeve clamps cover the threaded ends.

NOTE:

Prior to installing tapered end suspension components, clean male and female surfaces with brake clean.

Courtesy of CHRYSLER GROUP, LLC

Install the drag link end to the adjustment sleeve (4).

Courtesy of CHRYSLER GROUP, LLC
Install the drag link (3) to knuckle (5).
Install the drag link/tie rod to knuckle nut (2) and tighten to specifications. Refer to LINKAGE, LINK AND COIL, TECHNICAL SPECIFICATIONS .
Install the cotter key (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the supports and lower the vehicle. Center the steering wheel and adjust the toe. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .
After adjustment tighten tie rod adjustment sleeve jam nuts to specifications. Refer to LINKAGE, LINK AND COIL, TECHNICAL SPECIFICATIONS .