LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 152 (Heated Seats (Service Information)) >> Switch, Heated Seat >> Removal >> Rear

Switch, Heated Seat: Removal: Rear

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Floor Console Rear Trim Panel
GC0085469Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Using a trim stick (special tool # (special tool #C-4755, Trim Stick)) or equivalent, gently pry the upper edge of the floor console rear trim panel (1) to release the retaining clips at all of the locations around the floor console rear trim panel (3).
  3. Lift up and rearward to release the panel lower tabs (2) from the floor console.
    Fig 2: Rear Heated Seat Switches & Auxiliary Jacks
    GC0085470Courtesy of CHRYSLER GROUP, LLC
  4. If equipped, disconnect the 2nd row heated seat switches (1), 115 Volt power outlet (3) and the auxiliary audio jacks (2) electrical connectors from the floor console rear trim panel.
  5. Using a trim stick (special tool # (special tool #C-4755, Trim Stick)) or equivalent, gently pry the 2nd row heated seat switch assembly out of the trim panel.
scientia non olet · About LEMON Manuals