Diagnostic Test
WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT DRIVER DOOR SWITCH ASSEMBLY FOR DAMAGE NOTE:
Diagnose and repair all LIN Bus related Diagnostic Trouble Codes (DTC's) before performing this test procedure.
- Turn the ignition off.
- Inspect the Driver Door switch assembly for damage.
Is the switch assembly damaged?
Yes
- Replace the Driver Door switch assembly in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Go To 2.
- INSPECT FOR OBJECT OR SUBSTANCE CAUSING RIGHT MIRROR SELECT SWITCH TO STAY OR STICK IN A PUSHED POSITION
- Inspect the Right Mirror Select switch for anything that would cause it to stay or stick in a pushed position.
Is anything present that would cause the Right Mirror Select switch to stay or stick in a pushed position?
Yes
- Repair as necessary.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Go To 3.
- Inspect the Right Mirror Select switch for anything that would cause it to stay or stick in a pushed position.
- TEST FOR INTERMITTENT CONDITION
- Turn the ignition on.
- Using a scan tool, record and erase DTC's.
- Press and release the Right Mirror Select switch several times and then wait 30 seconds.
- Using a scan tool, read DTC's.
Is the same DTC active?
Yes
- Replace the Driver Door switch assembly in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- The conditions that caused this code to set are not present at this time.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .