Diagnostic Test
WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- VERIFY IF DTC B1D00-2A MIRROR FOLD SWITCH INPUT STUCK IS ACTIVE
- Turn the ignition on.
- With the scan tool, erase the DTC's.
- Press the Mirror Fold Switch in both directions several times.
- Cycle the ignition from on to off three times.
- Turn the ignition on.
- With the scan tool, read the active DTC's.
Does the scan tool display active: B1D00-2A MIRROR FOLD SWITCH INPUT STUCK?
Yes
- Replace the Drivers Door Window/Mirror Switch Assembly in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and poor pin fit. Repair as necessary.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .