Module, Drivetrain Control: Operation: Operation: Inputs/Outputs
WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
The following are inputs to the DTCM:
- Transfer Case Mode Sensor Signal
- 1 Direct Battery Feed
- Ignition RUN Sense
- Sensor Ground
- Module Ground
- CAN C Bus
The following are outputs of the DTCM:
- Transfer Case Motor Brake Control
- 5V Sensor Supply
- Transfer Case Bi-directional Motor Control (A AND B)
- Switched B+ Solenoid Supply
- Transfer Case Motor Brake Control