LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Message Center (Service Information)) >> Center, Electronic Vehicle Information >> Standard Procedure >> Reset Perform Service Indicator

Reset Perform Service Indicator

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

The Perform Service  message will display on the Electronic Vehicle Information Center (EVIC) each time you turn the ignition switch to the ON/RUN position to indicate that emission system scheduled maintenance is required. After performing the scheduled maintenance, reset the Perform Service  indicator using the following procedure:

  1. Turn the ignition switch to the ON position, but do not start the engine.
  2. Depress and release the brake pedal two times.
  3. Fully depress and release the accelerator pedal slowly two times within 10 seconds.
  4. Turn the ignition switch to the OFF/LOCK position.
NOTE:

If the indicator message illuminates when you start the engine, the Perform Service indicator did not reset. If necessary, repeat this procedure.

scientia non olet · About LEMON Manuals