LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Message Center (Service Information)) >> Center, Electronic Vehicle Information >> Standard Procedure >> Reset Oil Change Indicator

Reset Oil Change Indicator

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

After performing the needed maintenance, reset the Oil Change Required  indicator using the following procedure:

  1. Turn the ignition switch to the ON position, but do not start the engine.
  2. Fully depress and release the accelerator pedal slowly three times within 10 seconds.
  3. Turn the ignition switch to the OFF/LOCK position.
NOTE:

If the Oil Change Required indicator message illuminates when you start the engine, the indicator did not reset. If necessary, repeat this procedure.

scientia non olet · About LEMON Manuals