LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Restraints (Service Information)) >> Sensor, Impact >> Removal >> Side >> B-Pillar - Except Standard Cab

B-Pillar - Except Standard Cab

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Side Impact Sensor (B-Pillar)
GC0088207Courtesy of CHRYSLER GROUP, LLC
  1. Adjust the driver or passenger side front seat to its most forward position for easiest access to the B-pillar trim.
  2. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
  3. Remove the trim from the inside of the lower B-pillar. Refer to PANEL, B-PILLAR TRIM, LOWER, REMOVAL .
  4. Disconnect the body wire harness connector (1) from the side impact sensor (2) connector receptacle.
  5. Remove the screw (3) that secures the sensor to the inner B-pillar.
  6. Remove the sensor from the inner B-pillar.
scientia non olet · About LEMON Manuals