Diagnostic Test
WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR AN INTERMITTENT CONDITION NOTE:
This vehicle has a Front I/P Speaker wired in parallel with the Front Door Speaker.
- Turn the ignition on and open one of the front doors.NOTE:
A front door must remain open whenever checking or erasing Radio DTC's.
- Using the scan tool, record and erase the Radio DTC's.
- Turn the Radio on.
- Adjust the speakers to the front and center.
- Using the scan tool, read the active Radio DTC's.
Does the scan tool read: B1402-FRONT LEFT AUDIO SPEAKER OUTPUT CIRCUIT HIGH?
Yes
- Go To 2.
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- Turn the ignition on and open one of the front doors.
- CHECK FOR VOLTAGE ON THE (X201) LEFT FRONT SPEAKER (+) CIRCUIT
Courtesy of CHRYSLER GROUP, LLC
- Turn the ignition off.
- Disconnect the Radio C1 harness connector.
- Disconnect the Left Front Door Speaker harness connector.
- Disconnect the Left Front I/P Speaker harness connector.
- Turn the ignition on.
- Measure the voltage between ground and the (X201) Left Front Speaker (+) circuit.
Is there any voltage present?
Yes
- Repair the (X201) Left Front Speaker (+) CIRCUIT FOR A SHORT TO VOLTAGE.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Go To 3.
- CHECK FOR VOLTAGE ON THE (X291) LEFT FRONT SPEAKER (-) CIRCUIT
Courtesy of CHRYSLER GROUP, LLC
- Measure the voltage between ground and the (X291) Left Front Speaker (-) circuit.
Is there any voltage present?
Yes
- Repair the (X291) Left Front Speaker (-) CIRCUIT FOR A SHORT TO VOLTAGE.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Replace the Radio in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- Measure the voltage between ground and the (X291) Left Front Speaker (-) circuit.