Diagnostic Test

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

TEST FOR AN INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, record and erase any Instrument Cluster DTC's.
3. Turn the ignition off, wait ten seconds then turn the ignition on.
4. With the scan tool, read DTC's.
  Does the scan tool display: B222C-VEHICLE CONFIGURATION NOT PROGRAMMED?
  
  Yes
  - Go To 2.
  No
  - The condition that caused this code to set is not present at this time. Using the wiring diagram as a guide, inspect the wiring and connectors for an intermittent condition. Operate the system several times and recheck for active DTC's.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
VERIFY COMMUNICATION WITH TIPM
1. With the scan tool in ECU VIEW, read active modules on the bus.
  Does the scan tool show the TIPM active on the bus?
  
  Yes
  - Go To 3.
  No
  - Refer to COMMUNICATION - DIAGNOSIS AND TESTING and perform the No Response From TIPM diagnostic procedure.
CHECK TIPM FOR ACTIVE DTC's
1. With the scan tool, erase TIPM DTC's.
2. Turn the ignition off. Wait approximately ten seconds.
3. Turn the ignition on.
4. With the scan tool, read TIPM DTC's.
  Are any active DTC's present?
  
  Yes
  - Refer to TIPM - DIAGNOSIS AND TESTING and perform the appropriate diagnostic procedure.
  No
  - Go To 4.
CHECK CLUSTER VEHICLE INFORMATION WITH SCAN TOOL
1. With the scan tool in Cluster ECU Identification, read the Original and Current VINs, and the Body Style of the vehicle.
  Does the information displayed match the vehicle?
  
  Yes
  - Replace the Instrument Cluster in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the TIPM in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .