LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Starting (Service Information)) >> Starter >> Installation >> 5.7L

Section 137 (Starting (Service Information)): Starter: Installation: 5.7L

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Starter Electrical Connectors
GC0087583Courtesy of CHRYSLER GROUP, LLC
  1. Connect the solenoid wire to starter motor (snaps on).
  2. Position the battery cable to the solenoid stud. Install and tighten the battery cable eyelet nut to 13 N.m (10 ft. lbs.). Do not allow the starter motor to hang from the wire harness.
    Fig 2: Starter Mounting Bolts
    GC0087582Courtesy of CHRYSLER GROUP, LLC
  3. Position the starter motor to engine.
  4. If equipped with automatic transmission, slide the cooler tube bracket into position.
  5. Install and tighten both mounting bolts. Tighten to 68 N.m (50 ft. lbs.).
  6. Lower the vehicle.
  7. Connect the negative battery cable.
scientia non olet · About LEMON Manuals