LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 136 (Emissions Control) >> Exhaust Gas RECIRCULATION Valve, 6.7L Diesel >> Valve, Exhaust Gas RECIRCULATION (EGR), 6.7L Diesel >> Removal >> Pick Up Models

Pick Up Models

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: EGR Crossover Tube Cover
GC0108069Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect both negative battery cables.
  2. Remove bolts (1) and the EGR crossover tube cover (2).
    Fig 2: EGR Crossover Tube, Clamps & Connector
    GC0137182Courtesy of CHRYSLER GROUP, LLC
  3. Loosen clamp (1). Remove clamp (3) at end of EGR crossover tube (2).
  4. Remove bolt (5) at center bottom of EGR crossover tube.
    Fig 3: EGR Valve Assembly & Bolts
    GC0108459Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the EGR valve harness connector.
  6. Remove the four EGR valve assembly mounting bolts (1).
  7. Remove EGR valve assembly (2) from intake connector (3) by prying up.
    Fig 4: EGR Valve Gaskets
    GC0110296Courtesy of CHRYSLER GROUP, LLC
  8. Remove crossover tube gasket (1) and clean EGR valve. Also clean end of EGR tube of any old gasket material.
  9. Remove two gaskets on bottom EGR valve (4). Clean bottom of EGR valve and top of its intake connection point of any old gasket material.
scientia non olet · About LEMON Manuals