LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 136 (Emissions Control) >> Exhaust Gas RECIRCULATION Valve, 6.7L Diesel >> Valve, Exhaust Gas RECIRCULATION (EGR), 6.7L Diesel >> Installation >> Pick Up Models

Pick Up Models

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: EGR Valve Gaskets
GC0110296Courtesy of CHRYSLER GROUP, LLC
  1. Install a new EGR crossover tube gasket (1).
  2. Install a new gasket (4) to bottom of EGR valve (2).
    Fig 2: EGR Valve Assembly & Bolts
    GC0108459Courtesy of CHRYSLER GROUP, LLC
  3. Position EGR valve assembly (2) and install the four EGR valve mounting bolts (1) finger tight.
    Fig 3: EGR Crossover Tube, Clamps & Connector
    GC0137182Courtesy of CHRYSLER GROUP, LLC
  4. Install clamps (3) at end of EGR crossover tube (2).
  5. Install bolt (5) at center bottom of EGR crossover tube finger tight.
  6. Tighten clamp (3) first to 10 N.m. (89 in. lbs.), then tighten clamp (1) to 10 N.m. (89 in. lbs.).
  7. Tighten bolt (5) to 10 N.m (89 in. lbs.).
    Fig 4: EGR Valve Assembly & Bolts
    GC0108459Courtesy of CHRYSLER GROUP, LLC
  8. Tighten the four EGR valve mounting bolts (1) in a cross-cross fashion to 24 N.m (18 ft. lbs.).
    9. Fig 5: EGR Temperature Sensor
    GC0110284Courtesy of CHRYSLER GROUP, LLC
  9. Connect the EGR valve harness connector (5).
    Fig 6: EGR Crossover Tube Cover
    GC0108069Courtesy of CHRYSLER GROUP, LLC
  10. Install EGR crossover tube cover (2). Tighten bolts (1) to 10 N.m (89 in. lbs.).
  11. Connect both negative battery cables.
scientia non olet · About LEMON Manuals