Cab/Chassis Models

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: EGR Valve Gaskets

Courtesy of CHRYSLER GROUP, LLC

Install new gasket (1) to end of EGR tube.

Fig 2: EGR Valve Assembly & Bolts
Courtesy of CHRYSLER GROUP, LLC
Position EGR valve assembly (2) and install the four EGR valve mounting bolts (1) finger tight.

Fig 3: EGR Crossover Tube
Courtesy of CHRYSLER GROUP, LLC
Install and lightly tighten two clamps (1) and (3) at ends of EGR crossover tube.
Install "P" clamp bolt (5) finger tight only.
Tighten clamp (1) first to 10 N.m. (89 in. lbs.), then tighten clamp (3) to 10 N.m. (89 in. lbs.).
Tighten "P" clamp bolt (5) to 10 N.m (89 in. lbs.).

Fig 4: EGR Valve Assembly & Bolts
Courtesy of CHRYSLER GROUP, LLC
Tighten the four EGR valve mounting bolts in a criss-cross fashion to 24 N.m (18 ft. lbs.).

Fig 5: EGR Temperature Sensor
Courtesy of CHRYSLER GROUP, LLC
Connect the EGR Actuator harness connector (5).

Fig 6: EGR Crossover Tube Cover
Courtesy of CHRYSLER GROUP, LLC
Install EGR crossover tube cover (2). Tighten bolts (1) to 10 N.m (89 in. lbs.).
Connect both negative battery cables.