LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 136 (Emissions Control) >> Exhaust Gas RECIRCULATION Valve, 6.7L Diesel >> Tube, Exhaust Gas RECIRCULATION (EGR), Crossover >> Installation >> Cab/Chassis Models

Cab/Chassis Models

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: EGR Crossover Tube
GC0110290Courtesy of CHRYSLER GROUP, LLC
  1. Clean each end of EGR crossover tube, and its connection points of any old gasket material
  2. Install new gaskets (doughnuts) to each end of tube.
  3. Position EGR crossover tube (2) to engine.
  4. Position "P" clamp (5) at center of EGR crossover tube. Install "P" clamp bolt loosely (finger tight).
  5. First, tighten EGR crossover tube clamp (1) to 10 N.m (89 in. lbs.), then tighten clamp (3) to 10 N.m (89 in. lbs.).
  6. Tighten "P" clamp bolt (5) to 10 N.m (89 in. lbs.).
  7. Connect harness connector (4) to EGR temperature sensor.
    Fig 2: EGR Crossover Tube Cover
    GC0108069Courtesy of CHRYSLER GROUP, LLC
  8. Install the EGR crossover tube cover (1). Tighten bolts (2) to 10 N.m (89 in. lbs.).
  9. Connect both negative battery cables.
scientia non olet · About LEMON Manuals