LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (Charging System (Service Information)) >> Generator >> Installation >> 3.7L / 4.7L

3.7L / 4.7L

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the generator to the engine and install the two horizontal bolts and the one vertical bolt. Tighten all three bolts to 55 N.m (40 ft. lbs.).
  2. Snap the field wire connector into the rear of the generator.
  3. Install the B+ terminal eyelet to the generator output stud. Tighten to 12 N.m (8.8 ft. lbs.).
    CAUTION:

    Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.

    CAUTION:

    When installing a serpentine accessory drive belt, the belt must be routed correctly. The water pump may be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or refer to INSTALLATION .

  4. Install the accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
  5. Connect the negative battery cable.
scientia non olet · About LEMON Manuals