LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (6.7L Engine (Service Information)) >> Lubrication >> Oil >> Standard Procedure >> Engine Oil Level

Engine Oil Level

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Oil Level Indicator (Dipstick)
GC0108597Courtesy of CHRYSLER GROUP, LLC
1 - ADD OIL MARK
2 - O-RING
3 - SAFE RANGE
CAUTION:

Do not overfill crankcase with engine oil, oil foaming and oil pressure loss can result.

To ensure proper lubrication of an engine, the engine oil must be maintained at an acceptable level. The acceptable oil level is in the SAFE RANGE (3) on the engine oil dipstick.

NOTE:

Note: The best time to check the engine oil level is after the engine is at operating temperature and has been turned off (not running) for 30 minutes.

  1. Position vehicle on level surface.
  2. With engine OFF, allow approximately 30 minutes for oil to settle to bottom of crankcase, remove engine oil dipstick.
  3. Wipe dipstick clean.
  4. Replace dipstick and verify it is seated in the tube.
  5. Remove dipstick, with handle held above the tip, take oil level reading.
  6. Add oil only if level is below the SAFE RANGE area on the dipstick.
  7. Replace dipstick.