LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (6.7L Engine (Service Information)) >> Engine Mounting >> Insulator, Engine Mount, Front >> Removal >> Pick Up

Pick Up

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Frame Mount Fasteners
GC0137135Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect both negative battery cables.
  2. Remove the viscous fan/drive assembly. Refer to FAN, COOLING, ELECTRIC, REMOVAL and FAN, COOLING, VISCOUS, REMOVAL .
  3. Install Engine Support Fixture tool (special tool #8534B, Fixture, Driveline Support).
  4. Loosen the right side and left side thru-bolt and nut (1).
  5. Lift the engine SLIGHTLY  and remove the thru-bolt and nut (1).
    Fig 2: RH Engine Mount & Bolts
    GC0137136Courtesy of CHRYSLER GROUP, LLC
  6. Remove bolts (1) and the RH mount (2) from engine.
    Fig 3: LH Engine Mount & Bolts
    GC0137137Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    4x4 engine mount shown in illustration 4x2 similar.

  7. Remove bolts (1) and the LH mount (2) from engine.
scientia non olet · About LEMON Manuals