LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (6.7L Engine (Service Information)) >> Engine Block >> Rod, Piston And Connecting >> Standard Procedure >> Standard Procedure - Head Gasket Selection

Standard Procedure - Head Gasket Selection

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure piston protrusion for all six pistons.
  2. Calculate the average piston protrusion. Maximum allowable protrusion is 0.516 - 0.485 mm (0.006 - 0.019 in.).
    NOTE:

    There is only one head gasket available for the 6.7L engine.

scientia non olet · About LEMON Manuals