LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (6.7L Engine (Service Information)) >> Cylinder Head >> Valves, Intake And Exhaust >> Installation >> Installation

Valves, Intake And Exhaust: Installation: Installation

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install rocker housing. Refer to COVER(S), CYLINDER HEAD, INSTALLATION, 6.7L .
  2. Install fuel injectors and high pressure fuel lines. Refer to INJECTOR(S), FUEL, INSTALLATION .
  3. Lubricate the valve tips and install the crossheads in their original locations.
  4. Lubricate the crossheads and push rod sockets and install the rocker arms and pedestals in their original locations. Tighten bolts to 36 N.m (27 ft. lbs.).
  5. Verify valve lash adjustment. Refer to  VALVE LASH ADJUSTMENT AND VERIFICATION  .  
  6. Install cylinder head cover gasket onto rocker housing. Refer to COVER(S), CYLINDER HEAD, INSTALLATION, 6.7L .
  7. Install injector solenoid nuts.
  8. Connect injector harness connectors.
  9. Install cylinder head cover. Refer to COVER(S), CYLINDER HEAD, INSTALLATION, 6.7L .
  10. Connect both negative battery cables.
scientia non olet · About LEMON Manuals