LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (6.7L Engine (Service Information)) >> Cylinder Head >> Cover(S), Cylinder Head >> Removal >> Cylinder Head Cover

Cylinder Head Cover

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Engine Cover & Bolts
GC0108069Courtesy of CHRYSLER GROUP, LLC
  1. Remove the bolts (1) and the engine cover.
  2. Disconnect both negative battery cables.
    Fig 2: Cylinder Head Cover Components
    GC0108506Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Pneumatic tools should NOT be used to remove or install the cover.

  3. Remove the oil fill cap.
  4. Remove the breather cover capscrews.
  5. Remove the Close Crankcase Ventilation (CCV) cover (4) and breather filter.
  6. Disconnect the CCV Tube (1) at the Crankcase Depression Regular (CDR) valve.
  7. Disconnect the crankcase pressure sensor connector (2).
  8. Remove the CCV oil drains (3) from cylinder head cover (2 hoses).
  9. Remove the cylinder head cover capscrews.
  10. Remove the cylinder head cover.
    Fig 3: Injector Harness Nuts, Cylinder Head Cover/Injector Wiring Gasket & Injector Wiring Harness Connectors
    GC0108507Courtesy of CHRYSLER GROUP, LLC
  11. Disconnect both injector harness connectors.
  12. Remove the injector wire nuts (1) from the valve cover gasket.
  13. Remove the cylinder head cover gasket (2).
scientia non olet · About LEMON Manuals