LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (6.7L Engine (Service Information)) >> Cylinder Head >> Cover(S), Cylinder Head >> Installation >> Cylinder Head Cover Gasket

Cylinder Head Cover Gasket

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Injector Harness Nuts, Cylinder Head Cover/Injector Wiring Gasket & Injector Wiring Harness Connectors
GC0108507Courtesy of CHRYSLER GROUP, LLC
1 - INJECTOR NUTS
2 - GASKET
3 - INJECTOR HARNESS CONNECTORS
  1. Clean off any oil from cylinder head cover gasket
  2. Inspect cylinder head cover gasket for cuts or damage. Replace if damaged.
  3. Install cylinder head cover gasket (2).
  4. Install injector solenoid nuts (1) at injectors. Tighten to 1.25 Nm (11 in. lbs.).
  5. Connect injector harness connectors (3) at cylinder head cover gasket.
scientia non olet · About LEMON Manuals