LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (5.7L Engine (Service Information)) >> Lubrication >> Pan, Oil >> Removal >> Removal >> 4X4

Pan, Oil: Removal: Removal: 4X4

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Oil Pan Removal/Tightening Sequence
GC0082908Courtesy of CHRYSLER GROUP, LLC
  1. Follow all steps for 4X2 removal.
  2. Unbolt and lower the steering rack, without disconnecting the lines.
    NOTE:

    The front axle must be lowered to remove the oil pan on 4X4 vehicles.

  3. Remove the front driveshaft at the axle. Mark for reassembly.
  4. Support the front axle.
  5. Remove the right and left axle to mount bolts.
  6. Lower axle.
  7. Remove the oil pan mounting bolts and oil pan.
  8. Unbolt oil pump pickup tube and remove tube.
    NOTE:

    When the oil pan is removed, a new integral windage tray and gasket assembly must be installed. The old gasket cannot be reused.

  9. Discard the integral windage tray and gasket and replace.
scientia non olet · About LEMON Manuals