Cover(S), Cylinder Head: Removal: Removal

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Negative Battery Cable

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable (1).

Fig 2: Oil Fill Cap & Engine Cover
Courtesy of CHRYSLER GROUP, LLC
Remove the engine cover (2). Refer to COVER, ENGINE, INSTALLATION, 5.7L .

Fig 3: Ignition Coil Electrical Connectors, Harness & Bolts
Courtesy of CHRYSLER GROUP, LLC

NOTE:
Right side shown in illustration, left side similar.
Disconnect the ignition coil electrical connectors (1).
Position the electrical harness (2) aside.
Remove the ignition coil retaining bolts (3) and remove the ignition coils.

Fig 4: Cylinder Head Cover Removal/Tightening Sequence
Courtesy of CHRYSLER GROUP, LLC
Using the sequence shown in illustration, remove the cylinder head cover retaining bolts.
CAUTION:
Do not use harsh cleaners to clean the cylinder head covers. Severe damage to covers may occur.

Fig 5: Cylinder Head & Cover
Courtesy of CHRYSLER GROUP, LLC
Remove the cylinder head cover (1).
Clean the sealing surface of the cylinder head (2) and cover.

NOTE:

The cylinder head cover gasket may be used again, provided no cuts, tears, or deformation have occurred.