Diagnostic Test
WARNING: This page is about a different car, the 2016 RAM 3500 HD and 2016 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
PROGRAM THE POWERTRAIN CONTROL MODULE
- Verify the PCM is at the latest calibration (flash level).NOTE:
An intermittent loss of power to the PCM without performing an ETC Relearn procedure may cause this DTC to set.
- Replace and reprogram the Powertrain Control Module in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
- Start the engine.
- Allow the engine to reach normal operating temperature.
- Operate the accelerator pedal. (do not exceed 3500 RPM).
- With the scan tool, check for DTCs.NOTE:
Diagnose any other DTCs that may have set with the P062C.
Does this DTC reset by itself?
Yes
- Replace and reprogram the Powertrain Control Module in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
- Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
No
- Test Complete.