LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1322 (66RFE Automatic Transmission (Service Information) 2500 Hd & 3500 Hd) >> Cable, Shift >> Removal >> Removal

Cable, Shift: Removal: Removal

WARNING: This page is about a different car, the 2016 RAM 3500 HD and 2016 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Gearshift Cable At Transmission
GC0109171Courtesy of CHRYSLER GROUP, LLC
1 - GEARSHIFT CABLE
2 - RFE TRANSMISSION
3 - MANUAL LEVER
  1. Shift transmission into PARK.
  2. Raise vehicle.
  3. Disengage cable (1) eyelet at transmission manual shift lever (3) and pull cable adjuster out of mounting bracket.
    Fig 2: Gearshift Cable At Dash Panel
    GC0109172Courtesy of CHRYSLER GROUP, LLC
    1 - GEARSHIFT CABLE
    2 - GROMMET
  4. Lower the vehicle.
  5. Remove the dash panel insulation pad as necessary to access the gearshift cable grommet (2).
  6. Remove grommet (2) from the dash panel.
    Fig 3: Grommet, Gearshift Cable & Column Bracket
    GC0155156Courtesy of CHRYSLER GROUP, LLC
  7. Remove any steering column trim necessary to access the gearshift cable (2).
  8. Disconnect the BTSI wiring connector.
  9. Disconnect cable at lower column bracket (3) and shift lever pin and pull the cable through the dash panel opening into the vehicle.
  10. Remove gearshift cable (2) from vehicle.
scientia non olet · About LEMON Manuals