Switch, Oil Pressure: Removal: Removal
WARNING: This page is about a different car, the 2012 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - BELT |
| 2 - OIL PRESSURE SENSOR |
| 3 - OIL FILTER |
| 4 - ELEC. CONNECTOR |
- Disconnect the negative cable from the battery.
- Raise vehicle on hoist.
- Remove front splash shield.
- Disconnect oil pressure sender wire (4).
- Remove the pressure sender (2). Refer to Fig 1.