LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (3.7L Engine (Service Information)) >> Engine Block >> Damper, Vibration >> Installation >> Installation

Damper, Vibration: Installation: Installation

WARNING: This page is about a different car, the 2012 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Damper Installer & A/C Hub Installer Cup
GC0087852Courtesy of CHRYSLER GROUP, LLC
CAUTION:

To prevent severe damage to the crankshaft, damper, and damper installer (special tool #8512A, Installer, Damper), thoroughly clean the damper bore and the crankshaft nose before installing damper.

  1. Position the damper onto the crankshaft.
  2. Assemble the damper installer (special tool #8512A, Installer, Damper) (2) and the A/C hub installer cup (special tool #6871, Installer, A/C Hub) (1).
    Fig 2: Pressing Damper Onto Crankshaft
    GC0087853Courtesy of CHRYSLER GROUP, LLC
  3. Using the damper installer (special tool #8512A, Installer, Damper) (2) and the A/C hub installer cup (special tool #6871, Installer, A/C Hub) (1), press the damper onto the crankshaft.
  4. Coat the vibration damper bolt threads with Mopar ® Nickel Anti-Seize or equivalent, install and tighten the bolt to 175 N.m (130 ft. lbs.).
  5. Install the cooling fan assembly. Refer to FAN, COOLING, ELECTRIC, INSTALLATION and FAN, COOLING, VISCOUS, INSTALLATION .
  6. Install the radiator upper shroud and tighten fasteners to 11 N.m (95 in. lbs.).
  7. Install the radiator upper hose.
  8. Install the accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
  9. Refill the cooling system. Refer to STANDARD PROCEDURE .
  10. Connect the negative battery cable.
scientia non olet · About LEMON Manuals