3.7L/4.7L/5.7L Engine

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exhaust Pipe, Manifold Bolts & J-Nuts

Courtesy of CHRYSLER GROUP, LLC

Raise and support the vehicle.
Unplug the upstream and downstream oxygen sensors. Swap over the sensors as necessary.
Remove and discard the exhaust pipe to manifold bolts (1) and J-nuts (2).
Loosen the exhaust pipe to Y-pipe clamp and separate the two pipes.
Shift the rear exhaust pipe rearward.
Carefully remove the exhaust system Y-pipe.