LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Lamps/Lighting - Exterior (Service Information)) >> Standard Procedure >> Standard Procedure - Front Lamp Aiming >> Fog Lamp Alignment

Fog Lamp Alignment

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

A properly aimed front fog lamp will project a pattern on the alignment screen 10 centimeters (4 inches) below the fog lamp centerline and straight ahead of the lamp.

Fig 1: Thumbwheel Screw
GC0087640Courtesy of CHRYSLER LLC
  1. Turn the fog lamps ON.
  2. Rotate the thumbwheel screw (1) located behind the bumper on the back of each fog lamp unit to adjust the beam height as required.
scientia non olet · About LEMON Manuals