LAMP, Underhood: Removal: Lamp
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative cable.
- From the underside of the hood, remove the push-in retainers that secure the hood silencer pad to the inner hood (1) reinforcement as necessary to access the underhood lamp connection to the underhood lamp jumper wire harness (2).
- Disconnect the underhood jumper wire harness connector from the underhood lamp (3) connector receptacle.
- Remove the bulb from the underhood lamp. Refer to LAMP, Underhood , Removal .
- Remove the blind rivet (4) that secures the underhood lamp mounting bracket to the inner hood reinforcement (1).
- Remove the underhood lamp and bracket from the inner hood reinforcement as a unit.