Bulb - Rear Fender
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
These lamps are used on vehicles with a pick-up bed and dual rear wheels only. A lamp with an amber lens is located on the rear fender ahead of each rear wheel opening, and a lamp with a red lens is located on the rear fender behind each rear wheel opening. The bulb types and service procedures are identical for all four of these lamps.
- Disconnect and isolate the battery negative cable.
- Using hand pressure, press the rear edge of the rear fender marker lamp lens/housing (4) toward the front of the vehicle against the spring pressure of the retaining clip, then pull the rear edge of the lamp outward to disengage it from the mounting hole in the rear fender.
- Pull the lamp out from the rear fender far enough to access the bulb socket (1) on the back of the lamp lens/housing.
- Firmly grasp the bulb socket on the back of the lamp lens/housing and rotate it counterclockwise about 30 degrees to unlock it.
- Pull the socket and bulb straight out from the keyed opening in the housing.
- Pull the base of the bulb (3) straight out of the socket.