Sensor, Exhaust Pressure: Removal: Removal

WARNING: This page is about a different car, the 2016 RAM 3500 HD and 2016 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Cover, Bolts & Oil Dipstick

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate both negative battery cable.
Remove the oil dip stick (2).
Remove the bolts (1) and the engine cover (3).

Fig 2: Exhaust Pressure Sensor Wire Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Remove the exhaust pressure sensor wire harness connector (1).

Fig 3: Exhaust Pressure Sensor
Courtesy of CHRYSLER GROUP, LLC
Remove the exhaust pressure sensor (1).

Fig 4: Outside Bracket Mounting Bolt
Courtesy of CHRYSLER GROUP, LLC
If required, remove bolt (2) securing the exhaust pressure sensor tube (1) to EGR cooler bracket.
If required, remove fitting (3) and the exhaust pressure sensor tube (1).