Sensor, Transmission Range: Installation: Installation
WARNING: This page is about a different car, the 2016 RAM 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - ALIGNMENT HOLE |
| 2 - BOLT |
| 3 - TRANSMISSION RANGE SENSOR |
| 4 - STAKE WASHER AND NUT |
| 5 - CONTROL SHAFT |
| 6 - ALIGNMENT TOOL 2013100210 |
- Install the transmission range sensor (3) onto the control shaft (5).
- Install the stake washer and the nut (4) and hand tighten.
- With the transmission in neutral install the alignment tool (special tool #2013100210, Tool, TRS Alignment) (6) onto the control shaft (5) and into the alignment hole (1).
- Install the bolts (2).
- After aligning the transmission range sensor, tighten the bolts (2) 12.5 N.m (9 ft.lbs.).
- Remove the alignment tool (special tool #2013100210, Tool, TRS Alignment) (6).
- Tighten the control shaft nut to 7 N.m (62 in.lbs.).
- Bend the tabs on the stake washer and nut (4) in at least two places to lock in position.
1 - TRANSMISSION RANGE SENSOR 2 - MANUAL SHIFT LEVER 3 - CONTROL SHAFT NUTS - Install the manual shift lever (2) onto the control shaft.
- Install the inner nut (3) onto the control shaft. Tighten the inner nut to 12.5 N.m (9 ft.lbs).
- Install the outer nut (3) onto the control shaft. While holding the inner nut, tighten the outer not to 12.5 N.m (9 ft.lbs).