3.7L Engine
WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - MOUNTING SCREWS |
| 2 - MAP SENSOR |
| 3 - ECT SENSOR |
| 4 - FRONT OF INTAKE MANIFOLD |
- Apply thread sealant to ECT sensor threads.
- Install ECT sensor (3) to engine.
- Tighten sensor to 11 N.m (8 ft. lbs.) torque.
- Connect electrical connector to ECT sensor (3).
- Replace any lost engine coolant. Refer to STANDARD PROCEDURE .