3.7L/4.7L Engine
WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - WATER PUMP |
| 2 - TIMING CHAIN COVER |
- Clean the gasket mating surfaces.
- Using a new gasket, position water pump and install the mounting bolts. Tighten the water pump mounting bolts to 24 N.m (18 ft. lbs.).
- Spin the water pump to be sure that the pump impeller does not rub against the timing chain case/cover.
- Connect the radiator lower hose to the water pump.
- Install accessory drive belt tensioner. Refer to TENSIONER, BELT, INSTALLATION .
- Install the drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
- Install the radiator fan. Refer to FAN, COOLING, VISCOUS, INSTALLATION .
- Evacuate air and refill the cooling system. Refer to PUMP, WATER, STANDARD PROCEDURE .
- Connect the negative battery cable.
- Check cooling system for leaks. Refer to LEAK TESTING .