LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1277 (Steering System - 2500 Hd & 3500 Hd) >> Linkage, Link And Coil >> Drag Link, Steering, Link And Coil >> Removal >> To Knuckle

To Knuckle

WARNING: This page is about a different car, the 2016 RAM 3500 HD and 2016 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Tightening Tie Rod Adjustment Sleeve Clamp Bolt
GC0161598Courtesy of CHRYSLER GROUP, LLC
  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Loosen the jam nuts on the drag link adjuster sleeve (4) as necessary.
    Fig 2: Removing Tie Rod From Knuckle With Special Tool
    GC0152017Courtesy of CHRYSLER GROUP, LLC
  3. Remove the cotter key (1) and the drag link/tie rod to knuckle nut (2).
  4. Remove the drag link end (3) from the knuckle (5) with (special tool #10390, Separator, Tie Rod).
  5. Remove the drag link end (3) from the adjuster sleeve.
scientia non olet · About LEMON Manuals