When Monitored

WARNING: This page is about a different car, the 2016 RAM 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.

This diagnostic runs continuously when the following conditions are met:

TCM supply voltage is between 10 and 16 volts.
Engine speed (CAN Message) is greater than 550 RPM.
No engine speed (CAN message or signal) DTCs set.
Ignition switch RUN position signal is detected via dedicated circuit to TCM.
No ignition switch DTCs set.
No linear solenoid DTCs set.
No hydraulic pressure circuit DTCs set.
No ON/OFF solenoid DTCs set.
No gear ratio DTCs set.
No turbine speed sensor DTCs set.
Linear Solenoid 6 command pressure is greater than or equal to 560 kPa.