When Monitored

WARNING: This page is about a different car, the 2016 RAM 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.

This diagnostic runs continuously when the following conditions are met:

The TCM supply voltage is between 10 and 16 volts.
The engine speed (CAN message) is greater than or equal to 550 RPM or the turbine speed is greater than or equal to 550 RPM.
Time elapsed since one of the above conditions met is less than ten seconds.
Ignition switch Run position signal is detected via dedicated circuit to TCM.
No ignition switch DTCs set.
No output speed sensor DTCs set.
The Output speed is greater than a calibrated RPM.
No linear solenoid DTCs set.
No on/off solenoid DTCs set.
No hydraulic pressure circuit DTCs set.
No shift range sensor DTCs set.
Shift range indicator position is D.
No turbine speed sensor DTCs set.
TCM gear commanded is equal to the gear that the DTC is set for.
Transmission is not currently shifting.
Transmission sump temperature is greater than -19°C (-2°F).
No gear ratio DTCs set for any other gear.