When Monitored

WARNING: This page is about a different car, the 2016 RAM 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.

This diagnostic runs continuously when the following conditions are met:

TCM supply voltage is between 10 and 16 volts.
Engine is running and engine speed (CAN Message) is greater than 550 RPM.
No ignition switch DTCs set.
Transmission range sensor is not in park or neutral and the transmission is not currently shifting.
No CAN bus DTCs.
No turbine speed sensor electrical failures.
There are no transmission range sensor failures.
Shift position is not in park or neutral and the transmission is not currently shifting.
TCM is not in neutral control mode for a calibrated amount of time.
The turbine speed based calculated output speed is greater than 807 RPM, and the wheel speed-based calculated output shaft speed is greater than or equal 360 RPM.