When Monitored And Set Conditions
WARNING: This page is about a different car, the 2016 RAM 3500 HD and 2016 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
When Monitored: continuously when the following condition is met:
- Ignition on.
Set Conditions:
- This DTC sets if the stored configuration does not match the configuration stored in the controller.
| Possible Causes |
|---|
| VEHICLE CONFIGURATION NOT STORED IN THE BODY CONTROL MODULE (BCM) |
| CONTROL MODULE INSTALLED IN INCORRECT VEHICLE |
| HVAC MODULE |
Always perform the PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding. Refer to HVAC PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE .