Bulb - Cab And Chassis
WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The rear lamp unit contains two bulbs: the park/turn signal/brake/license plate, and the backup. The service procedures for each bulb are the same, only the bulb sizes and types may differ.
- Disconnect and isolate the battery negative cable.
- Remove the four screws (1) that secure the lens (2) to the rear lamp unit housing (5).
- Push the backup lamp bulb (4), or the park/turn signal/brake/license plate bulb (7) slightly into its socket (3) or (6), then rotate the bulb counterclockwise about 30 degrees to unlock it.
- Pull the base of the bulb straight out of the socket.