LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 125 (Lamps/Lighting - Exterior (Service Information)) >> Lamp, Cab >> Removal >> Lamp

Lamp, Cab: Removal: Lamp

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Molded Gasket, Socket, Plastic Nuts & Screws
GC0137099Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the two screws (2) that secure the cab clearance lamp lens/housing and the molded gasket (1) to the outer roof panel.
  3. Pull the lamp away from the roof panel far enough to access the socket (4) on the underside of the lamp lens/housing.
  4. Firmly grasp the lamp socket on the underside of the lamp housing and rotate it counterclockwise about 30 degrees to unlock it.
  5. Pull the socket and bulb straight out from the keyed opening in the housing.
  6. Remove the cab clearance lamp lens/housing from the roof panel.
  7. Remove the two plastic nuts (3) from the holes in the roof panel and discard.
scientia non olet · About LEMON Manuals