Spring, Front Coil: Installation: Installation

WARNING: This page is about a different car, the 2016 RAM 3500 HD and 2016 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Part Number Label Tag

Courtesy of CHRYSLER GROUP, LLC

NOTE:

When installing the front coil springs, the part number label tag (1) must be positioned down closest to the axle spring seat.

Fig 2: Coil Spring & Shock

Courtesy of CHRYSLER GROUP, LLC

Install the upper and lower spring isolators (if needed).
NOTE:
Rotation of the spring and prying down slightly on the axle will aid in installation.
Position the coil spring into the upper isolator mount. It may be necessary to rotate the spring while installing.
Raise the axle into position until the spring seats in the lower axle isolator mount.

Fig 3: Stabilizer Bar Link & Nuts
Courtesy of CHRYSLER GROUP, LLC
Install the stabilizer bar links (2) and shock absorbers at the axle and tighten fasteners to specifications. Refer to FRONT, LINK AND COIL, SPECIFICATIONS .

Fig 4: Electrical Connector, Retainer & Axle Actuator
Courtesy of CHRYSLER GROUP, LLC
Connect the electrical connector (1) and retainer (3) to the axle actuator (2).
Remove the hydraulic jack from under the axle.
Install the front wheel house splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, INSTALLATION .
Install the wheel and tire. Refer to WHEELS, STANDARD PROCEDURE .
Remove the supports and lower the vehicle.